Название: Inventions in the Century
Автор: Doolittle William Henry
Издательство: Public Domain
Жанр: Зарубежная классика
isbn:
isbn:
So slow was the invention and introduction of new devices, that if Ruth had revisited the earth at the beginning of the nineteenth century, she might have seen again in the fields of the husbandmen everywhere the sickle of the reapers behind whom she gleaned in the fields of Boaz, heard again the beating on the threshing floor, and felt the old familiar rush of the winnowing wind. Cincinnatus returning then would have recognised the plough in common use as about the same in form as that which he once abandoned on his farm beyond the Tiber.
But with the spread of publications, the extension of learning, the protection now at last obtained and enforced for inventions, and with the foundations laid and the guide-posts erected in nearly every art and science by previous discoverers, inventors and writers, the century was now ready to start on that career of inventions which has rendered it so glorious.
As the turning over and loosening of the sod and the soil for the reception of seed was, and still is the first step in the art of agriculture, the plough is the first implement to be considered in this review.
A plough possesses five essential features, – a frame or beam to which the horses are attached and which is provided with handles by which the operator guides the plough, a share to sever the bottom of a slice of land – the furrow – from the land beneath, a mould board following the share to turn the furrow over to one side, and a landside, the side opposite the mould board and which presses against the unploughed ground and steadies the plough. To these have been commonly added a device called the coulter, which is a knife or sharp disk fastened to the frame in advance of the share and adapted to cut the sod or soil so that the furrow may be more easily turned, an adjustable gauge wheel secured to the beam in advance of the coulter, and which runs upon the surface of the soil to determine by the distance between the perimeter of the wheel at the bottom and the bottom of the plough share the depth of the furrow, and a clevis, which is an adjustable metal strap attached to the end of the beam to which the draught is secured, and by which the pitch of the beam and the depth and width of the furrow are regulated. The general features, the beam, handles, and share, have existed in ploughs from the earliest ages in history. A plough with a metal share was referred to by the prophecy of Isaiah seven centuries before Christ, "They shall beat their swords into plough-shares;" and such a plough with the coulter and gauge wheel added is found in the Caylus collection of Greek antiquities. The inventions of centuries in ploughs have proceeded along the lines of the elements above enumerated.
The leading features of the modern plough with a share and mould board constructed to run in a certain track and turn its furrows one over against the other, appear to have originated in Holland in the 18th century, and from there were made known to England. James Small of Scotland wrote of and made ploughs having a cast-iron mould board and cast and wrought iron shares in 1784-85.
In America, about the same time, Thos. Jefferson studied and wrote upon the proper shape to be given to the mould board.
Charles Newbold in 1797 took out the first patent in the United States for a plough – all parts cast in one piece of solid iron except the beam and handles.
It is a favourite idea with some writers and with more talkers, that when the necessity really arises for an invention the natural inventive genius of man will at once supply it. Nothing was more needed and sought after for thirty centuries among tillers of the soil than a good plough, and what finally supplied it was not necessity alone, but improved brains. Long were the continued efforts, stimulated no doubt in part by necessity, but stimulated also by other motives, to which allusion has already been made, and among which are the love of progress, the hope of gain, and legislative protection in the possession of inventive property.
The best plans of writers and inventors of the eighteenth century were not fully developed until the nineteenth, and it can be safely said that within the last one hundred years a better plough has been produced than in all of the thousands of years before. The defects which the nineteenth century's improvements in ploughs were designed to remedy can best be understood by first realising what was the condition of ploughs in common use when the century opened.
Different parts of the plough, such as the share and coulter, were constructed of iron, but the general practice among farmers was to make the beam and frame, handles and mould board of strong and heavy timber. The beam was straight, long, and heavy, and that and the mould generally hewed from a tree. The mould board on both sides to prevent its wearing out too rapidly was covered with more or less thick plates of iron. The handles were made from crooked branches of trees. "The beam," it is said, "was set at any pitch that fancy might dictate, with the handles fastened on almost at right angles with it, thus leaving the ploughman little control over his implement which did its work in a very slow and imperfect manner." It was some such plough that Lord Kames complained about in the Gentleman Farmer in 1768, as being used in Scotland – two horses and two oxen were necessary to pull it, "the ridges in the fields were high and broad, in fact enormous masses of accumulated earth, that could not admit of cross ploughing or cultivation; shallow ploughing universal; ribbing, by which half the land was left untilled, a general practice over the greater part of Scotland; a continual struggle between the corn and weeds for superiority." As late as 1820 an American writer was making the same complaint. "Your furrows," he said, "stand up like the ribs of a lean horse in the month of March. A lazy ploughman may sit on the beam and count every bout of his day's work; besides the greatest objection to all these ploughs is that they do not perform the work well and the expense is enormous for blacksmith work." It was complained by another that it took eight or ten oxen to draw it, a man to ride upon the beam to keep it on the ground, and a man followed the plough with a heavy iron hoe to dig up the "baulks."
The improvements made in the plough during the century have had for their object to lessen the great friction between the wide, heavy, ill-formed share and mould board, and the ground, which has been accomplished by giving to the share a sharp clean tapering form, and to the mould board a shape best calculated to turn the furrow slice; to improve the line of draught so that the pull of the team may be most advantageously employed, which has been effected after long trials, study and experiment in the arrangement of beam, clevis and draft rod, setting the coulter at a proper angle and giving the landside a plane and parallel surface; to increase the wear and lessen the weight of the parts, which has been accomplished by ingenious processes in treating the metal of which the parts are composed, and lessening the number of parts; to render the plough easily repairable by casting the parts in sets and numbering them, by which any part may be replaced by the manufacturer without resort to the blacksmith. In short there is no part of the plough but what has received the most careful attention of the inventor. This has been evidenced by the fact that in the United States alone nearly eleven thousand patents on ploughs were issued during the nineteenth century. When it is considered that all the applications for these patents were examined as to their novelty, before the grant of the patent, the enormous amount of study and invention expended on this article can be appreciated. Among the century's improvements in this line is the use of disks in place of the old shovel blades to penetrate the earth and revolve in contact therewith. Cutting disks are harnessed to steam motors and are adapted to break up at one operation a wide strip of ground. The long-studied problem of employing a gang of ploughs to plough back and forth and successfully operated by steam has been solved, and electricity is now being introduced as a motor in place of steam. Thus millions of broad acres which never would have been otherwise turned are now cultivated. The tired muscle-strained ploughman who homeward plodded his weary way at night may now comfortably ride at his ease upon the plough, while at the same time the beasts that pull it have a lighter load than ever before.
Next to the plough among the implements for breaking, clearing and otherwise preparing the soil for the reception of seed, comes the harrow. From time immemorial it has been customary to arm some sort of a frame with wooden or iron spikes to scratch the earth after the ploughing. But this century has greatly improved the old constructions. Harrows are now found everywhere СКАЧАТЬ