The Barnet Book of Photography: A Collection of Practical Articles. Various
Чтение книги онлайн.

Читать онлайн книгу The Barnet Book of Photography: A Collection of Practical Articles - Various страница 3

СКАЧАТЬ

      Photographers in England are rarely afflicted with breathlessness through exertion, but it is different in mountaineering. A mountaineer may keep his wind, but it would be rare to find that his heart was beating equably after some spurt of exertion, such as rock climbing. It is often after some such exertion that he comes upon some view which he may wish to record on his photographic plate. The usual method of holding the hand camera would under such circumstances prove a failure so far as sharpness of image is concerned. Pressed against his "middle" or "upper" chest, the beatings of the heart will record themselves on the photograph. Under such circumstances resort must be had to some form of support on which to rest his camera. After many years' experience, the writer has come to the conclusion that there is no support superior to the ice axe. It is not necessary to cause it to stand upright in the ground, ice, or snow, though this should be done if possible. It will suffice to rest the point on the rock, and place the camera on the axe head, with the pick parallel to the body. We then have a firm support in one direction, and the hands, which are not affected by the automatic motion of the heart, can be trusted to keep it steady in the other direction. Photographs taken with a good lens, and with such a stand, will bear enlarging up to 22 inches, at least. It is because these photographs will bear enlarging that a small plate is recommended to the mountaineer. There is not a large proportion of Alpine views taken on the mountain side of which one would care to have anything but a memorandum, and it is such a size as that recommended which gives such a memento, and which, if desired, allows a more formidable size to be acquired at home, where we may suppose there are all the conveniences that a photographic laboratory affords. The writer has had experience on mountains with cameras varying from 12 × 10 to the ¼ plate size. When younger and more inclined to waste a few valuable minutes of daylight in putting up a camera stand, the 12 × 10 gave pictures which we often lamented having taken, whilst in his more mature years, a snap-shot has never been regretted. The cameras which require stands, require one porter at least to carry them, for although the late Mr. Donkin carried his own 7½ × 5 camera up the highest peaks, it is few men, who, even if they had the energy or the physique that he had, would imitate his example. A porter means an extra expense in fees, and an extra mouth to feed, and very likely entails slowness in a climb through having an additional man upon the rope. A quarter plate or a 5 × 4 camera the owner, however, can himself carry; but the best form of attaching it to his body has been a difficult task to evolve. Many and many different attachments have been tried. One thing is quite certain, and that is, the camera should be in a stout case, but it cannot be carried over the shoulders by a strap as we can do in comparatively level countries. Let anyone try to come down a rock with the camera slung over his shoulders, and he will soon find it dangling in front of his stomach, or swinging like a pendulum, and threatening to displace him from what at best may be a treacherous handhold. The method of attachment we adopt now, will be readily seen from the diagram.

      The shoulder strap is utilized, but a ring is attached to the back of the case as shown, and a strap or piece of whipcord comes over the strap as shown. The two shoulders are in AA and the case is carried as a knapsack. The length of the cord or strap BB is so adjusted, as is also the length of the shoulder strap, that the camera lies against the small of the back, and that it will not swing away from the body. At one time the ring was placed in front of the case, but the result was merely to cause the top of the case to rest against the back. The plan shown above has answered under almost every variety of circumstances, and the weight is inconsiderable. (A friend has his camera attached to the bottom of a small "rücksac" and this answers, but as the writer does not carry his own provisions or change of garments he has not adopted this plan). A long day's march may be undertaken if this contrivance be employed, and the weight is scarcely felt.

      For those who have not had extensive practice with hand cameras, a view finder is, if not a necessity, at all events, a great help. On the whole, perhaps the best form is that in which a miniature view falls on a ground glass. It must be recollected, however, that each view finder is adapted for some particular focal length of lens. The view in the finder and on the plate should be compared, and if the former is more extensive, the surplus ground glass should be covered up with a black mask.

      If it be determined to take a camera with its stand, very few directions are required beyond those which apply to ordinary view work on the plains. It may perhaps be as well to mention that a camera stand placed on ice or snow, is not immovable until the iron shoes of the legs attain the temperature of the surrounding snow or ice. An exposure of a few seconds will often show an image which has moved on the plate.

      The next point that we may call attention to is the plate to be employed. With a hand camera there is no absolute necessity to have the most rapid plate, as far as exposure is concerned, but in mountain work it must be recollected that there are very great contrasts to represent on the print. "The slower the plate the steeper the gradation" is almost axiomatic, and it must be recollected that only a certain amount of opacity will print if the deepest shadows only are to be kept of the greatest black obtainable in a print. It is evident that the greater the range of light and shade that is obtained of a printable density, the more true to nature the picture will be. For this reason a quick plate with a moderate gradation is to be preferred—as being most generally useful—but it should be a plate which is absolutely free from fog, and it should also be of as fine a grain as possible, the size of which has something to do with development. This is still more true when a camera stand and hand exposures are made. With a slow plate with feebler intensities of light, which must be the case when the lens is stopped down to admit of hand exposures, the gradation becomes more steep than if a fairly bright light be employed. A quick plate does not suffer in the same way, however small the stop may be. It has already been stated that isochromatic plates may be employed with a hand camera. For ice and snow views there is not much to commend their employment, unless to give a deeper shade to the sky and to the vast crevasses which so often form part of the foreground. The darker sky allows faint clouds to be visible in a print when they otherwise would be absent. Pictorially thus the isochromatic plate has something to recommend it. Celluloid films have often been substituted for plates by the writer, and excellent photographs have been obtained on them when they were fairly rapid. There is not much to be said in their favour as regards weight, for in most cameras the support for them weighs nearly as much as the glass plate. There is also a disadvantage in developing them, for they are not so easily manipulated as a rigid body. For convenience in travelling, however, they are to be highly commended. A gross of cut films do not weigh so much as a dozen plates and occupy much less space in the baggage. The question of the use of a Kodak camera with its roller slide, has not been brought forward, not because excellent results cannot be obtained with it, but simply because the writer prefers to use plates and films which can be got at any time for the purpose of development.

      For travelling on the continent, and to one's mountain destination, experience has shown that a small hamper is the safest receptacle of all the necessary kit. A hamper which will contain two camera cases side by side is really sufficient; but it should be a little greater in depth. It may be thought that two cameras are to be taken, but such is not the intention. If a zinc trough be made of the size of one camera case it will contain all the developing apparatus necessary, the lantern, and the plates or films, and all the few etceteras which go to make one happy. (A screwdriver, a file, and some extra screws, and gummed paper and white blotting paper cut to the size of the plates should be enough for the etceteras). The hamper may be arranged so that the camera and view finder may be taken out without any derangement of the rest of the articles in it. The developing bottles and cups, with the dishes, may be similarly extracted. This prevents undue trouble in unpacking and packing. One grand thing to remember is, pack well but not distressingly tightly, in other words don't employ an expert packer if you wish for comfort. Have the hamper a size too large rather than a size too small. Also be it remembered that it is useless to stopper the bottles with all sorts of devices at home, and have to pack in an ordinary manner when once the contents of the hamper have been brought into use. Have your bottles covered with an indiarubber cap which can easily be removed and replaced; of course we are assuming that development is to take place during one's travels, СКАЧАТЬ