The Gun Digest Book of Tactical Weapons Assembly/Disassembly. J B Wood
Чтение книги онлайн.
Читать онлайн книгу The Gun Digest Book of Tactical Weapons Assembly/Disassembly - J B Wood страница 6
Название: The Gun Digest Book of Tactical Weapons Assembly/Disassembly
Автор: J B Wood
Издательство: Ingram
Жанр: Спорт, фитнес
isbn: 9781440224300
isbn:
5. Move the barrel slightly forward, then remove it downward and toward the rear. Gun is now field-stripped.
Browning BDA 380 field-stripped
Detail Strip:
6. The extractor pin is drifted out upward.
7. With the safety in the on-safe position, remove the extractor toward the right.
8. Remove the extractor spring from its recess in the slide.
9. Use a small roll pin punch to drift out the roll pin in the base of the right safety-lever, downward.
10. Turn the safety-lever upward to clear its lower tab, and remove it toward the right.
11. Move the safety toward the left until it stops, and remove the firing pin from the rear of the slide. The safety must be in the off-position.
12. Be sure the firing pin spring is at the front of its tunnel, and remove the safety toward the left. The safety positioning ball and spring are staked in place, and should not be removed.
13. Remove the firing pin spring from the slide.
14. Depress the takedown-latch lock button, turn the lever up to vertical position, and remove the latch toward the right.
15. Remove the grips, using a screwdriver with a wide and very thin blade. If necessary, grind or file one to fit.
16. Using the same screwdriver, remove the upper grip screw escutcheon on the right side.
17. With a tool or fingertip, unhook the lower arm of the magazine safety spring from its notch in the frame.
18. Lift the spring out of its slot in the frame, and move it inward to clear its upper loop from the opening in the trigger bar.
19. Turn the spring, and remove it toward the right.
20. Flex the upper arm of the trigger bar spring downward and outward, disengaging it from its slot in the underside of the trigger bar. Pull the trigger to give clearance, and lift the spring out of its recess.
21. Remove the trigger bar toward the right.
22. The cross-shaft of the slide latch is also the trigger pivot. Lift the slide latch at the rear to clear the frame, and move it slightly toward the left. Insert a small screwdriver to disengage the upper arm of the slide latch spring from its shelf in the frame.
23. Remove the slide latch toward the left, and take off its spring.
24. Remove the trigger spring upward.
25. Tip the top of the trigger down into the rear of the guard, and remove it toward either side.
26. Remove the takedown-latch lock button toward the right.
27. Insert a tool to push the longer left block in the rear of the magazine catch toward the right, while pushing the catch toward the left, into the magazine well.
28. When the right end of the catch clears the frame, swing it inward toward the rear, and remove the catch from the frame. For lefthanded shooters, the catch can be installed in reverse.
29. The retaining blocks and magazine catch spring can be removed, if necessary, by tipping the blocks outward. Control the spring during removal.
30. With the hammer in fired position, drift out the large roll cross-pin at the lower rear of the grip frame.
31. The hammer spring base should be forced out СКАЧАТЬ