The Gun Digest Book of Tactical Weapons Assembly/Disassembly. J B Wood
Чтение книги онлайн.
Читать онлайн книгу The Gun Digest Book of Tactical Weapons Assembly/Disassembly - J B Wood страница 10
Название: The Gun Digest Book of Tactical Weapons Assembly/Disassembly
Автор: J B Wood
Издательство: Ingram
Жанр: Спорт, фитнес
isbn: 9781440224300
isbn:
FNH Five-Seven field-stripped
Detail Strip:
4. It is possible to remove the recoil spring and it’s bushing from the barrel by retracting the bushing and spring, then prying off the retaining spring-ring. A vise and extreme caution will be necessary. In normal takedown, this system is left in place.
5. The slide components are contained in a subframe that is retained in the cover by this cross pin. It is splined at its right tip, and thus must be drifted out toward the right side. Be sure to use a non-marring brass drift punch.
6. Use a tool to gently pry the rear of the subframe outward slightly, as shown.
7. When the rear sight has cleared its opening in the cover, push the front sight inward and rearward, to detach the front lug of the sub-frame from its seat in the front of the cover. This will be visible at the front. Remove the sub-frame from the cover.
8. During the sub-frame removal, take care that the loaded-chamber indicator and its small coil spring are not lost. It would probably be wise to remove them at this point.
9. To remove the extractor and its coil spring, depress the extractor slightly at the rear and pull out the pivot pin. Control the spring.
10. Remove the cross pin at the rear of the subframe. It can be simply pushed out, no tool required.
11. Remove the firing pin and its return spring toward the rear.
12. If removal of the firing pin safety block and its spring is necessary, these parts can be taken out only upward, and you must first drift the rear sight assembly out of its dovetail-mount. Except for repair, this system is best left in place. This also applies to disassembly of the rear sight. If necessary, the front sight can be drifted out of its dovetail-mount.
13. Unless replacement is necessary, the action locking block and the other forward components should not be removed. If this has to be done, the locking block cross pin is drifted out toward the right. It is under slight spring tension, so control it. If the strong barrel rebound spring must be removed, it will be necessary to insert a spacer of some sort to hold the spring while the cross pin is drifted out toward the right. CAUTION: This spring is very powerful. If the parts above have been removed, the takedown latch can be moved rearward, its rear extension turned upward, and it is then moved inward to be taken out.
Конец ознакомительного фрагмента.
Текст предоставлен ООО «ЛитРес».
Прочитайте эту книгу целиком, купив полную легальную версию на ЛитРес.
Безопасно оплатить книгу можно банковской картой Visa, MasterCard, Maestro, со счета мобильного телефона, с платежного терминала, в салоне МТС или Связной, через PayPal, WebMoney, Яндекс.Деньги, QIWI Кошелек, бонусными картами или другим удобным Вам способом.